1. A saw, hammer, level, glue, and some wooden blocks are enough to install the Floating Parquet.
| INSTALLATION STEPS |
|
1. A saw, hammer, level, glue, and some wooden blocks are enough to install the Floating Parquet. |
|
2. Level the floor and spread the polystyrene foam or any other moisture-repellent insulant. |
|
3. Impregnate the whole length of the groove with glue and extend it over both sides with a paintbrush. |
|
4. Apply glue to the whole length of the tongue and spread it with a paintbrush. |
|
5. Leave a perimeter dry joint of 8 mm., which will be later covered by the skirting. |
|
6. Join the boards one by one with the help of a wooden block; be sure to hammer on the tongue, not on the groove. |
|
7. Wipe away the excess glue with a wet sponge and dry the surface with a cloth. |
|
8. Set the skirting board and the tops in place. |
